TM-9-2320-433-10
TRUCK, CARGO, GUIDED MISSILE TRANSPORTER (GMT), 8X8, M985E1
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-433-10 - Page 241 of 964
SETUP OUTRIGGERS - Continued
WARNING
Outrigger leg may slide out if vehicle is parked on an incline. Failure to
hold outrigger leg may result in injury to personnel.
2.
While holding outrigger leg (2) in place, remove outrigger beam retainer pin (3).
WARNING
If beam retainer stop is inoperative, beam could be pulled out too far and
fall, resulting in injury to personnel.
3.
Extend outrigger beam (4) by pulling outrigger leg (2) out slowly, until outrigger beam
(4) stops.
4.
Replace outrigger beam retainer pin (3) and beam retainer lock (1) to lock outrigger
beam (4) in place.
5.
Remove outrigger leg retainer lock (5).
WARNING
Failure to hold outrigger leg may cause leg to rotate and fall, resulting in
injury to personnel.
6.
While holding outrigger leg (2), remove outrigger leg pin (6); then slowly rotate
outrigger leg (2) to down position.
7.
Replace outrigger leg pin (6) and retainer lock (5) to secure outrigger leg (2) in down
position.
8.
Repeat Steps (1) through (7) for driver side outrigger.
TM 9-2320-433-10
0040
0040-7
Back to Top
