TM-9-2320-435-10
TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8, M1977
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-435-10 - Page 316 of 1168
OPERATION - Continued
CAUTION
When moving LHS hook arm rearward, ensure winch hydraulic hose lines
are not trapped or damaged.
20.
Position HOOK ARM switch (29) to UNLOAD and release when both hook arm
cylinders (30) are extended approximately 6 in. (15 cm).
21.
Position MAIN FRAME switch (31) to UNLOAD and release when bridge bay is clear
of vehicle and the BAP.
22.
Position WINCH switch (22) to OUT and release when bridge bay floats.
NOTE
Refer to TM 5-5420-209-12 for bridge bay operations.
23.
Have boat crew move in toward bridge bay and install pin and lanyard in secured
travel latch.
24.
Position MAIN FRAME switch (31) to UNLOAD and release when there is enough
slack in cable to remove cable hook (14) from bay lifting eye (15).
25.
Set HIGH IDLE switch (28) to OFF position.
26.
Have boat crewman remove winch cable hook (14) from bay lifting eye (15).
WARNING
After water operations, vehicle brakes will be wet and will not stop as
quickly as usual. Care must be taken and extra distance allowed for
slowing or stopping vehicle. Failure to comply may result in injury or death
to personnel and damage to equipment.
27.
Push in PARKING BRAKE control (26) and drive vehicle forward until clear of water.
Stop vehicle.
TM 9-2320-435-10
0044
0044-16
Back to Top
