TM-9-2330-267-14-P
TRAILER, TANK, WATER: 400 GALLON, 1-1/2 TON, 2 WHEEL M149, M149A1 AND M149A2
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
JULY 1991
TM-9-2330-267-14-P - Page 52 of 354
TM 9-2330-267-14&P
Section Il. SERVICE UPON RECEIP T
Page
Paragraph Title
Number
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2
Inspection Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2
Servicing Instruction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2
4-4. GENERAL .
When anew, used, or reconditioned water tank trailer is received, determine whether it has been properly
prepared for service and is capable of performing its mission. Follow the inspection instructions in paragraph4-5and
servicing instructions in paragraph 4-6.
4-5, INSPECTION INSTRUCTIONS .
a. Refer to DD Form 1397 for procedures on unpacking the water tank traiIer.
b. Remove all straps, plywood, tape, seals, and wrappings.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive
heat. The solvent’s flash point is 100°F-138°F (38°C-59°C). If you become dizzy
while using cleaning solvent, immediately get fresh air and medical help. If solvent
contacts eyes, immediately wash your eyes and get medical aid.
c. Remove rust preventive compound from coated exterior parts of the water trailer using dry cleaning solvent
(Item 9, Appendix E) and rags (Item 18, Appendix E).
d. Inspect water tank trailer for damage incurred during shipment. Check also to see if the equipment
been modified.
e. Check the equipment against the packing list to ensure that the shipment is complete. Report
discrepancies in accordance with instructions in DA Pam 738-750.
4-6. SERVICING INSTRUCTIONS .
a. Perform all Operator/Crew and Organizational PMCS. Schedule the next PMCS on DD Form 314.
b. Lubricate all lubrication points as described in Chapter 3, Section I, regardless of interval.
c. Report any problems on DA Form 2407.
d. Perform a break-in road test of 25 mi (40 km) at a maximum speed of 50 mi/h (80 km/h).
has
any
4-2
Back to Top
