TM-9-2330-330-14-P
SEMITRAILER, FUEL TANKER: 5000-GALLON, FUEL-DISPENSING, AUTOMOTIVE, M969A3
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
NOVEMBER 2005
TM-9-2330-330-14-P - Page 29 of 1116
TM 9-2330-330-14&P
ix/x blank
HOW TO USE THIS MANUAL—Continued
DA Form 2028
DA Form 2028 is used to report errors and to recommend improvements for the tasks in this manual.
Metric Conversion Chart
This metric conversion chart converts English measurements to metric equivalents. Measurements in this
manual are provided in both English and metric units.
WARNINGS, CAUTIONS, AND NOTES
You must read and understand this manual BEFORE operating the semitrailer.
Throughout this manual, you will see
WARNING, CAUTION,
and
NOTE
headings. There are good
reasons for every one of these notices:
WARNING
A warning is used to alert the user to hazardous operating and maintenance
procedures, practices, or conditions that could result in injury or death. Warnings
must be strictly observed.
CAUTION
A caution is used to alert the user to hazardous operating and maintenance
procedures, practices, or conditions that could result in damage to, or destruction
of, equipment or mission effectiveness. Cautions must be strictly observed.
NOTE
A note highlights an essential operating or maintenance procedure, condition, or
statement.
Warnings and cautions appear immediately preceding the step to which they pertain. It is important to
read and thoroughly understand the warnings and/or cautions before beginning maintenance. Notes may
precede or follow the steps to which they pertain, depending on what makes the most sense.
INITIAL SETUPS
Before starting a task, you must obtain all the tools, supplies, and personnel listed in the initial setup. Be
sure to read the task before performing the maintenance. If any other tasks are referenced, you must go
to the initial setup page for each of these tasks to find out what tools, supplies, and personnel will be
needed.
INDEXING
Three indexing procedures are used in this manual to help you locate information quickly:
•
Table of contents
•
Controls and indicators index in WP 0006 00
•
Alphabetical index at the back of this manual
Back to Top
