TM-9-2330-330-14-P

SEMITRAILER, FUEL TANKER: 5000-GALLON, FUEL-DISPENSING, AUTOMOTIVE, M969A3

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

NOVEMBER 2005

  TM-9-2330-330-14-P - Page 836 of 1116

TM 9-2330-330-14&P
0177 00-6
RPSTL INTRODUCTION — Continued
0177 00
NSN
When using this column to locate an
item, ignore the first four digits of the
NIIN
NSN.
However the complete NSN
should be used when ordering items by stock number.
FIG. Column.
This column lists the number of the figure where the item is identified/located.
The figures
are in numerical order in the repair parts list and special tools list work packages.
ITEM Column.
The item number identifies the item associated with the figure listed in the adjacent FIG.
column.
This item is also identified by the NSN listed on the same line.
2.
Part Number (P/N) Index Work Package.
P/Ns in this index are listed in ascending alphanumeric
sequence (vertical arrangement of letter and number combinations which places the first letter or digit
of each group in order A through Z, followed by the numbers 0 through 9 and each following letter or
digit in like order).
PART NUMBER Column.
Indicates the P/N assigned to the item.
FIG. Column.
This column lists the number of the figure where the item is identified/located in the repair
parts list and special tools list work packages.
ITEM Column.
The item number is the number assigned to the item as it appears in the figure referenced
in the adjacent figure number column.
SPECIAL INFORMATION
UOC. The UOC appears in the lower left corner of the Description Column heading.
Useable on codes
are shown as “UOC: …” in the Description Column (justified left) on the first line under the applicable
item/nomenclature.
Uncoded items are applicable to all models.
Identification of the UOCs used in the
RPSTL are:
Code Used
On
C94
M969A3
Fabrication Instructions.
Bulk materials required to manufacture items are listed in the bulk material
functional group of this RPSTL.
Part numbers for bulk materials are also referenced in the Description
Column of the line item entry for the item to be manufactured/fabricated. Detailed fabrication instructions
for items source coded to be manufactured or fabricated are found in Appendix (x) of this manual.
Index Numbers.
Items which have the word BULK in the figure column will have an index number shown
in the item number column.
This index number is a cross-reference between the NSN / P/N index work
packages and the bulk material list in the repair parts list work package.
HOW TO LOCATE REPAIR PARTS
1.
When NSNs or P/Ns Are Not Known.


Back to Top