TM-9-2350-238-20-1
HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL
MAY 1994
TM-9-2350-238-20-1 - Page 101 of 1364
TM 9-2350-238-20-1
Table 2-3. UNIT TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 2.
If problem still exists, notify direct support maintenance.
70. OIL PRESSURE IS TOO LOW.
Step 1.
Check transmission oil level.
Add or drain oil to proper level. Refer to the PMCS/lubrication table,
page 2-13.
Step 2.
Check all gaskets, joints, and plugs for signs of leakage.
Tighten all plugs and screws as required.
Step
3.
Check for damaged gage and sending unit.
Troubleshoot transmission oil pressure indicator circuit. Refer to
Electrical Circuit Symptom Index, page 2-92.
Step
4.
If problem still exists, notify direct support maintenance.
71. OIL PRESSURE IS TOO HIGH.
Step 7.
Check for clogged oil lines.
Clean or replace oil lines as required. Refer to page 2-418 and page
2-427.
Step 2.
Check for damaged gage and sending unit.
Troubleshoot transmission oil pressure indicator circuit. Refer to
Electrical Circuit Symptom Index, page 2-92.
Step 3.
If problem still exists, notify direct support maintenance.
72. OIL TEMPERATURE IS TOO HIGH.
Step 1.
Check transmission oil level.
Add or drain oil to proper level. Refer to the PMCS/lubrication table,
page 2-13.
2-75
Back to Top
