TM-9-2350-238-24P-2
CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE REPAIR, PARTS AND SPECIAL TOOLS LIST INCLUDING DEPOT MAINTENANCE, REPAIR PARTS AND SPECIAL TOOLS
MARCH 1992
TM-9-2350-238-24P-2 - Page 14 of 303
TM 9-2350-238-24P-2
(2) PART NUMBER column.
Indicates
the primary number used by the manufacturer
(individual, firm, corporation, or Government
activity), which controls the design and
characteristics of the item by means of its
engineering drawings, specifications stan-
dards, and inspection requirements to identify
an item or range of items.
(3) STOCK NUMBER column.
This col-
umn lists the NSN for the associated part
number and manufacturer identified in the
PART NUMBER and CAGEC columns to the
left.
(4) FIG. column.
This column lists the
number of the figure where the item is iden-
tified/located in Section II and Ill.
(5) ITEM column.
The item number is
that number assigned to the item as it ap-
pears in the figure referenced in the adjacent
figure number column.
c. Figure and Item Number Index.
(1) FIG. column.
This column lists the
number of the figure where the item is iden-
tified/located in Sections II and Ill.
(2) ITEM column.
The item number is
that number assigned to the item as it ap-
pears in the figure referenced in the adjacent
figure number column.
(5) PART NUMBER column.
Indicates
the primary number used by the manufacturer
(individual, firm, corporation, or Government
activity), which controls the design and
characteristics of the item by means of its
engineering drawings, specifications, stan-
dards, and inspection requirements to identify
an item or range of items.
5. SPECIAL INFORMATION
a. Fabrication Instructions.
Bulk materials
required to manufacture items are listed in the
Bulk Material Function Group of this RPSTL.
Part numbers for bulk materials are also
referenced in the description column of the
line item entry for the item to be manufac-
tured/fabricated. Detailed fabrication instruc-
tions for items source coded to be manufac-
tured or fabricated are found in TM 9-2350-
238-20-2 and TM 9-2350-238-34-2.
b. Assembly Instruction.
Detailed assem-
bly instructions for items source coded to be
assembled from component spare/repair parts
are found in TM 9-2350-238-20-2 and TM 9-
2350-238-34-2. Items that make up the as-
sembly are listed immediately following the
assembly item entry or reference is made to
an applicable figure.
c.
Kits.
Line item entries for repair parts
kits appear in a group in Section II (see table
of contents).
(3) STOCK NUMBER column.
This col-
d. Index Numbers.
Items which have the
umn lists the NSN for the item.
word BULK in the figure column will have an
(4) CAGEC column.
The Contractor and
index number shown in the item number col-
Government Entity Code (CAGEC) is a 5-digit
umn. This index number is a cross-reference
between the National Stock Number/Part
numeric code used to identify the manufac-
Number Index and the bulk material list in
turer, distributor, or Government agency, etc.,
Section Il.
that supplies the item.
7
Back to Top
