TM-9-2350-256-20-1

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 1 OF 2

NOVEMBER 2005

TM-9-2350-256-20-1 - Page 383 of 948

TM 9-2350-256-20-1

0065 00

CORRECTIVE ACTION –Continued

7.

Reconnect wire 27 at Y-connector. Install main switch panel (11), flat washer (10), ground lead (9),

three lockwashers (8), and three screws (7) to mounting brackets. Remove three screws (1), three

lockwashers (2), two screws (3), two lockwashers (4), and ground strap, and release gage panel (6)

from mounting bracket.

Disconnect switch panel to gage panel and miscellaneous switches wiring harness from gage panel.

Place red multimeter lead in socket K and black lead to ground. Turn MASTER switch on and check

for voltage. Turn MASTER switch OFF. If voltage is present, go to step 12. If voltage is not present,

repair/replace wire 27 of switch panel to gage panel and miscellaneous switches wiring harness (see

WP 0204 00 for dual voltage; 0205 00 for single voltage).

0065 00-7