TM-9-2350-256-20-1

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 1 OF 2

NOVEMBER 2005

  TM-9-2350-256-20-1 - Page 643 of 948

TM 9-2350-256-20-1
0096 00
ITEM
INTERVAL
MAN-
ITEM TO BE
PROCEDURE
EQUIPMENT
NO.
HOUR
CHECKED OR
NOT READY
SERVICED
AVA I L A B L E I F :
41
S
Stall Test
WARNING
Vehicle may move even with brakes in the locked
position.
CAUTION
Do not stall test engine for more than 30 seconds,
or converter will overheat.
a. Perform stall test.
1)
Run engine until normal operating temperature is
reached.
2)
Depress brake (3) to lock it in position; place
transmission (1) in high range and run the engine at full
throttle for 30 seconds.
Rpm below 1800 or above
1950.
3)
If the engine speed exceeds 1950 rpm, there is a
clutch slippage in the transmission. Check the shifting
control linkage adjustment (see WP 0361 00).
42
S
Acceleration and
Pulling Power
Test
NOTE
While testing in low range, accelerate with
wide-open throttle from low speed to top speed.
Governed speed under load should reach 1875
rpm, but not exceed 2640 rpm. If below 1875 rpm
or over 2640, notify Direct Support Maintenance.
a. Test for normal acceleration and pulling power in each transmis-
sion range.
Rpm below 1875 or over
2640.
0096 00-23


Back to Top