TM-9-2350-256-20-2

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 2 OF 2

JUNE 2005

TM-9-2350-256-20-2 - Page 548 of 1440

TM 9-2350-256-20-2

0281 00

Installation

1.

Install idler link bearing (36) in idler link (26).

2.

Connect one end of idler link (26) to roadwheel arm (31) with clevis pin (35), washer (34), nut (33), and cotter pin (32).

3.

Connect opposite end of idler link (26) to compensating idler arm (25) with clevis pin (30), washer (29), nut (28), and cotter

pin (27).

4.

Install spacer (24) to compensating idler arm (25).

5.

Install outer roller cup (23) to hub (16) using remover, replacer, and handle.

6.

Install inner roller cup (22) to hub using remover, replacer, and handle.

7.

Install, cone and roller (21), gasket (20), seal assembly (19), eight lockwashers (18), and eight screws (17) to hub (16).

8.

Install hub (16), cone and roller (15), round nut (14), two washers (12 and 13), nut (11), spring (10), gasket (9), access cover

(8), six lockwashers (7), and six screws (6). Torque screws to 20–25 lb-ft (27–34 N•m).

0281 00-4