TM-9-2350-256-24P-2
RECOVERY VEHICLE, FULL TRACKED; MEDIUM, M88A1; WINCH, POWER TAKE-OFF AND HOIST SYSTEM
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST
MAY 1992
TM-9-2350-256-24P-2 - Page 11 of 213
TM 9-2350-256-24P-2
C01
Code
Explanation
AO- (Assembled by
Org/AVUM Level)
AF- (Assembled by GS
Items with these codes are not to be requested/requisitioned individually. The
Category)
parts that make up the assembled item must be requisitioned or fabricated and
AH- (Assembled by
assembled at the level of maintenance indicated by the source code. If the 3
rd
SRA)
position of the SMR code authorizes you to replace the item, but the source code
AL- (Assembled by
indicates the item is assembled at a higher level, order the item from the higher level
SRA)
of maintenance.
AD- (Assembled by
Depot)
XA
XB
XC
XD
-
Do not requisition an “XA’ coded item. Order its next higher assembly. (Also, refer to the NOTE
below.)
-
If an ‘XB’ item is not available from salvage, order it using the CAGEC and part number given.
-
Installation drawing, diagram, instruction sheet, field service drawing, that is identified by
manufacturer’s part number.
-
Item is not stocked. Order an ‘XD’ coded item through normal supply channels using the
CAGEC and part number given, if no NSN is available.
NOTE: Cannibalization or controlled exchange, when authorized, may be used as a source of supply for items with the
above source codes, except for those source coded ‘XA” or those aircraft support items restricted by requirements
of AR 700-42.
(2)
Maintenance Code. Maintenance codes tell you the level(s) of maintenance authorized to USE and
REPAIR support items. The maintenance codes are entered in the third and fourth positions of the SMR
Code as follows:
(a)
The maintenance code entered in the third position tells you the lowest maintenance level
authorized to remove, replace, and use an item. The maintenance code entered in the third position will indicate
authorization to one of the following levels of maintenance.
Code
Application/Explanation
C
- Crew or operator maintenance done within unit or aviation unit maintenance.
O
- Unit or aviation unit category can remove, replace, and use the item.
F
- Direct support or aviation intermediate level can remove, replace, and use the
item.
H
- General support level can remove, replace, and use the item.
L
- Specialized repair activity can remove, replace, and use the item.
D
- Depot level can remove, replace, and use the item.
(b) The maintenance code entered in the fourth position tells whether or not the item is to be
repaired and identifies the lowest maintenance level with the capability to do complete repair (i.e., perform all authorized
repair functions). (NOTE: Some limited repair may be done on the item at a lower level of maintenance, if authorized by
the Maintenance Allocation Chart (MAC) and SMR codes.) This position will contain one of the following maintenance
codes.
3
Back to Top
