TM-9-2350-256-34
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
JULY 2005
TM-9-2350-256-34 - Page 116 of 584
TM 9-2350-256-34
0018 00
CORRECTIVE ACTION –Continued
35.
Check for defects in electrical circuit.
a.
Repair or replace defective components.
36.
Check for defective APU generator switch.
a.
Replace switch, if defective.
37.
Check for defective hydraulic pressure switch.
a.
Adjust or replace pressure switch (WP 0083 00).
38.
Check for damaged or defective APU generator (WP 0083 00).
a.
Replace defective generator (WP 0083 00).
39.
Remove APU from vehicle (WP 0083 00). Remove rear chain housing cover from APU (WP 0083 00).
Inspect drive chain and gears.
a.
Replace if defective (TM 9-2815-221-34&P).
40.
Check fuel system for air.
a.
Bleed air from fuel system.
41.
Operate APU with hydraulic system selector control lever in AUX position for 15 minutes.
42.
Check governor linkage (TM 9-2815-221-34&P).
a.
Repair, replace, or adjust governor linkage as required (TM 9-2815-221-34&P).
43.
Check engine timing (TM 9-2815-221-34&P).
a.
Retime engine (TM 9-2815-221-34&P).
44.
Test fuel injector pump (TM 9-2815-221-34&P).
a.
Replace fuel injector pump if defective (TM 9-2815-221-34&P).
45.
Test fuel injector nozzles (TM 9-2815-221-34&P).
a.
Replace fuel injector nozzles if defective (TM 9-2815-221-34&P).
46.
Check valve clearance (TM 9-2815-221-34&P).
a.
Adjust valve clearance (TM 9-2815-221-34&P).
47.
Check engine compression (TM 9-2815-221-34&P).
a.
Replace engine (WP 0083 00).
END OF WORK PACKAGE
0018 00-4
Back to Top
