TM-9-2350-256-34

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

JULY 2005

  TM-9-2350-256-34 - Page 95 of 584

TM 9-2350-256-34
0011 00
INTERMEDIATE MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
SPADE CIRCUIT (MAIN HYDRAULIC SYSTEM) TROUBLESHOOTING PROCEDURE
INITIAL SETUP:
Test Equipment
Gage (item 9, WP 0086 00)
Tester kit, hydraulic pump (item 20, WP 0086 00)
Tools and Special Tools
Tool kit, general mechanic’s (item 34, WP 0086 00)
References
TM 9-2350-256-20
WP 0051 00
WP 0065 00
WP 0066 00
Troubleshooting Procedure
Spade Circuit (Main Hydraulic System)
Symptom
Spade circuit (main hydraulic system) malfunctioning.
Malfunction
Spade will not operate.
Do steps 1 thru 15.
Spade will not hold with spade combination control valve lever in any position. Do steps 16 thru 19.
Spade will operate only partially.
Do steps 20 thru 23.
CORRECTIVE ACTION
1.
Attempt operation of main winch, hoist winch, and boom.
a.
If main winch, hoist winch, and boom operate, proceed to step 13.
b.
If main winch, hoist winch, and boom do not operate, proceed with step 2.
2.
Inspect mechanical transmission drive shaft.
a.
If not rotating, repair or replace (WP 0066 00).
3.
Inspect mechanical transmission for broken or restricted hose.
a.
Replace mechanical transmission hose (TM 9-2350-256-20).
4.
Inspect mechanical transmission output shaft. If not rotating, proceed with mechanical transmission
clutch pressure check. Install pressure gage in mechanical transmission clutch pressure line. For
location, refer to TM 9-2350-256-20. With engine operating at 1800 rpm and power control valve lever
in ON position, normal operating pressure is 150 ± 10 psi (1034 ± 69 kPa).
a.
Remove mechanical transmission and main hydraulic pump assembly (WP 0065 00).
b.
Replace mechanical transmission (WP 0065 00).
5.
Test for defective power control valve or restricted hose. Remove hose no. 66 from mechanical
transmission. With mechanical transmission drive shaft rotating, and power control valve lever placed
in ON position, oil should flow from hose.
a.
Replace defective power control valve (WP 0065 00).
b.
Replace restricted or damaged hose (TM 9-2350-256-20).
0011 00-1


Back to Top