TM-9-2350-261-20-4

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 4 OF 4

TM-9-2350-261-20-4 - Page 162 of 767

TM 9-2350-261-20-4

REPLACE M13 NBC HEATER WIRING HARNESS (M577A2 ONLY)

0670 00

THIS WORK PACKAGE COVERS:

Removal (page 0670 00-1).

Installation (page 0670 00-3).

INITIAL SETUP:

Maintenance Level

Unit

Tools and Special Tools

General Mechanic’s Tool Kit (WP 0780 00, Item 29)

Materials/Parts

Grommet

Locknut

Lockwasher (2)

Lockwasher (4)

Tie strap (AR)

Personnel Required

Unit Mechanic

Equipment Condition

Engine stopped (see your -10)

Carrier blocked (see your -10)

Battery ground lead disconnected (WP 0294 00)

REMOVAL

1.

Remove four screws (1), lockwashers (2), four clamps (3), and tie straps (4) from weldnuts in driver’s compartment.

Remove clamps from wiring harness (5) and cable (6). Discard lockwashers and tie straps.

NOTE

Tag all leads and cables before removing.

2.

Disconnect wiring harness (5) from control box (7).

3.

Remove screw (8), two lockwashers (9), and ground lead (10) from control box (7). Discard lockwashers.

4.

Remove screw (11), two washers (12), locknut (13), and ground lead (14) from panel (15). Discard locknut.

5 .

Cut

tie

strap (1 6) fro m groun d lead (14) an d wiring harness (5). Discard

tie

strap.

6.

Loosen screw on cable connector (17) and remove ground lead (14).

7.

Remove cable connector (17) from air purifier (18).

067000-1