TM 9-2350-277-10
EQUIPMENT DESCRIPTION — Continued
0002 00
MATERIAL USED WITH CARRIERS
Various kits can be applied to your carrier to prepare it for particular missions or operating conditions. Each kit is described
and illustrated on the following pages. If you have one or more of these kits on board, be sure to check the PREVENTIVE
MAINTENANCE CHECKS AND SERVICES (WP 0090 00). These kits include:
Personnel Heater Kit — All Carriers
Engine Coolant Heater Kit — All Carriers
Hospital Litter Kit — M113A3 Only
Windshield Kit — All Carriers
Gas Particulate Filter Unit M8A3 (NBC Kit) — All Carriers
Capstan and Anchor Kits — M1059A3
Smoke Grenade Launcher Kit — M113A3, M1059A3, and M58
Water/Ration Kit— M113A3 and M577A3
PERSONNEL HEATER KIT — ALL CARRIERS.
Provides heat to the rear compartment and driver’s compartment during
cold weather. It circulates warm air from the fresh air heater mounted in the right front corner of the rear compartment.
A heat duct along the front floor is manually controlled to direct the heat. Heater intake air is drawn form outside. The
exhaust is vented through the top deck. The heater control box is mounted to the left of the driver. It has a three-position
RUN-OFF-START switch, HI-LO switch, and indicator light. Location of the fuel pump for the personnel heater varies
with each vehicle (see illustration).
Heaters with part numbers D55350-F1 and 10560M24B1 are covered in this manual. For description, operation, and
troubleshooting of personnel heater, model A20, with part number 5000-30178, see TM 9-2540-207-14&P.
0002 00-48
Change 5