TM-9-2350-277-20-1

TM-9-2350-277-20-1 - Page 83 of 855

TM 9-2350-277-20-1

HOW TO USE THIS MANUAL (cont)

REFERENCES

References within a procedure refer to a different manual or to another procedure in the same manual. They are found in the

INITIAL SETUP and in the FOLLOW-THROUGH steps. For example.

MASTER SWITCH OFF. See TM 9-2350-277-10.

Battery ground lead disconnected (WP 0337 00 and WP 0339 00).

For all procedures, the following comments apply:

•Parts which are discarded when removed will be referred to as “new” in the procedure step when installed. Examples

are: gaskets, lockwashers, some preformed packings, and some retaining rings.

•These and other new parts are listed under MATERIALS/PARTS in the INITIAL SETUP.

GENERAL MAINTENANCE

Cleaning, inspecting, checking for leaks, and similar procedures which apply to most procedures are found under PMCS

and GENERAL MAINTENANCE INSTRUCTIONS (WP 0155 00). Use these steps to clean and inspect any part being

removed, repaired, or installed. Special cleaning will be covered in the procedure step. Below is a step that would require

general cleaning.

5. Remove gasket (2) from upper tube flange (1). Discard gasket.

After performing this step, you would clean the mating surface with cleaning compound and a wiping rag according to the

general cleaning procedures. In other procedures, hoses or rubber hatch seals will need to be checked for leaks. Refer to

PMCS and GENERAL MAINTENANCE INSTRUCTIONS (WP 0155 00) for general procedures.

xxxvi

Change 5