TM-9-2520-246-34-1

TRANSMISSION MODEL 3053A; TRANSMISSION TRANSFERS MODEL T-136-21 AND MODEL T-136-27; POWER TAKEOFFS MODEL WN-7-28, MODEL WND-7-28 AND MODEL P-136-C

TECHNICAL MANUAL; MAINTENANCE, DIRECT SUPPORT AND GENERAL SUPPORT LEVEL

JANUARY 1981

  TM-9-2520-246-34-1 - Page 82 of 418

TM 9-2520-246-34-1
2-10. ASSEMBLY OF SUBASSEMBLIES.
The following paragraphs from dust and
assemble the transmission subassemblies.
a.
NOTE
Keep all parts clean and protected from dust and
dirt.
Coat all bearings with multipurpose lubricant
during assembly.
Coat all oil seals with engine
lubricating oil during assembly. Coat shafts and
bores of gears with white lead pigment during
assembly.
Use new seals and snaprings during
assembly.
Input Shaft Assembly.
FRAME 1
1.
Set up input shaft (1) in hydraulic press as shown.
2.
Press bearing (2) into place.
3.
Take input shaft (1) out of press.
GO TO FRAME 2
2-62


Back to Top