TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 116 of 488

TM 9-2520-272-34&P

4-14 INSTALL CONVERTER ELEMENT COMPONENTS

(SHEET 5 OF 7)

NOTE

Balance marks are used on the clutch lockup

plate and on the converter pump housing.

The clutch lockup plate must be mounted so

that these two balance marks are aligned as

shown at the right.

17 Using 5/8 inch socket, remove plug (19) from hole at

side of converter housing. Rotate converter pump

housing until balance mark is visible through hole.

Using marker, mark top edge of pump above balance

mark for reference.

18 Install clutch lockup plate (18) on turbine (15) and on

converter pump (4) studs so that balance marks are

aligned.

Go to Sheet 6

TM85403

Para. 4-14, Task 1

4-53