TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 237 of 488

TM 9-2520-272-34&P

4-27.

ASSEMBLE BEVEL GEAR ASSEMBLY

32

33

34

35

36

37

38

39

40

41

42

(SHEET 5 OF 5)

Position bevel gear assembly, output oil pump upward,

as shown.

Using plastic faced hammer, install gear (33) and

bearing (32) onto shaft (2).

Install spacer (34) onto shaft (2).

Using external retaining ring pliers, install retaining

ring (35).

Using 1/2 inch socket and extension, install seven bolts

(36) and washers (37).

Using torque wrench, torque bolts (36) to 17-20 Ib-ft

(23-27 N•m).

Using hammer, install woodruff key (38) into slot in

input oil pump shaft (39).

Install driven gear (40) over shaft (39) and key (38).

Wedge screwdriver between driven gear (40) and drive

gear (33) to prevent gears from turning.

Using 3/4 inch socket, install nut (41) that retains gear

(40). Using torque wrench, check prevailing torque by

measuring the torque required to turn nut (41).

Using torque wrench, tighten nut (41) to 30 Ib-ft

(40 N•m) plus prevailing torque.

End of Task 1

Para. 4-27, Task 1

4-171