TM-9-2610-200-14
CARE, MAINTENANCE, REPAIR, AND INSPECTION OF PNEUMATIC TIRES AND INNER TUBES
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT; MAINTENANCE MANUAL
SEPTEMBER 2000
TM-9-2610-200-14 - Page 92 of 207
TM 9-2610-200-14
2-51
CHAPTER 2. CARE, MAINTENANCE, AND INSPECTION (Con't)
SECTION III.
UNIT MAINTENANCE (Con't)
2-30. BOLT TOGETHER RIMS REPAIR (M939A1 SERIES) (Con't)
.
c. ASSEMBLY (Con't)
10.
Remove two nuts (16) , two washers (17) , wheel assembly tool plate (15) , and wheel assembly tool
base (18).
11.
Torque self-locking nuts (14) alternately, in increments, and in sequence shown until 210-240 Ib.-ft.
(285-325 N.m).
.
12.
Install valve core (see paragraph 2-26).
13.
Inflate tire to proper pressure (see TM 9-2320-272-10) and install valve cap (6) on valve stem (5)
finger-tight.
FOLLOW-ON TASKS:
•
Install wheel (see TM 9-2320-272-10).
Back to Top
