TM-9-2815-200-35
ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)
TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
TM-9-2815-200-35 - Page 577 of 779
APPENDIX B
DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE
REPAIR PARTS AND SPECIAL TOOLS LIST
Section I INTRODUCTION
1. Scope
This appendix lists repair parts and special
tools required for the performance of direct
support, general support and depot maintenance
of Engine, with Container: Turbosupercharged,
Diesel, Fuel Injection, 90-degree “V” Type, Air
Cooled, 12 Cylinder Assembly, Continenta l
Models AVDS-1790-2M (2815-856-4996) ,
AVDS-1790-2A and AVDS-1790-2AM (2815 -
856.9005). Part number and Federal stoc k
number indexes are also included.
2. General
This Repair Parts and Special Tools List is
divided into the following sections:
a. Repair Parts - Section II.
A list of engine
parts, in Government Group number sequence
and keyed to figure and number, showin g
authorized repair parts for the performance of
maintenance at the direct support, genera l
support and depot levels.
b. Special Tools and Test Equipment -
Section III.
A list of special tools and test
equipment authorized for the performance of
maintenance at the direct support, genera l
support and depot levels is given in ascending
Federal stock number sequence, cross-referenced
to illustration figure number and item number.
Quantities shown in the Special Tools List are
those required for each support unit charged
with the responsibility of supporting thi s
equipment.
c. General Use Standardized Parts - Section
IV.
A list of all standard hardware and parts in
alphabetical part name order with the hardware
listed in ascending sizes.
d. Part Number and Federal Stock Numbe r
Indexes - Section V.
A list of part numbers and
Federal Stock numbers in ascending numerical
sequence, cross-referenced to the illustration
figure number and item number.
3. Explanation of columns
The following provides an explanation o f
columns in the tabular lists in Sections II and
III :
a. Source, Maintenance, and Recoverability
Codes (SMR), Column 1.
(1) Source code,
indicates the selection
status and source for the listed item. Source
codes
Code
“M”
“P”
“P2"
“X1”
“X2”
used are:
Explanation
Repair parts which are not procured or stocked as
separate supply items but are to be manufactured
in indicated maintenance levels. The lowest
maintenance level authorized to manufacture the
item will be entered in the second digit position of
the source code.
Repair parts which are high mortality parts,
stocked in or supplied from the GSA/DSA or
Army supply system, and authorized for use as
indicated maintenance categories
Repair parts which are procured and stocked for
insurance purposes because the combat or military
essentiality of the end item dictates that a
minimum quantity be available in the supply
system.
Applied to repair parts which are not procured or
stocked, the requirement for which will be
supplied by use of the next higher procured or
stocked component or assembly.
Applied to repair parts which are not stocked. The
indicated maintenance category requiring such
repair parts will attempt to obtain these parts by
cannibalization; if not obtainable by can-
nibalization,
such repair parts will b e
requieitioned with supporting justification
through normal supply channels.
B-1
Back to Top
