TM-9-2815-202-34

ENGINE, DIESEL W/CONTAINER: MODEL 7083-7395, 7083-7396, 7083-7398 AND 7083-7399

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

FEBRUARY 1990

  TM-9-2815-202-34 - Page 255 of 670

TABLE 4-5.
TM 9-2815-202-34
NOTE
A new standard size cylinder liner is
also classified as #1 (stamped
below flange), #2 (stamped above
ports), #3 (stamped below ports), or
#4 (stamped between ports and
flange).
(1) Before installing liner in used cylinder
(2) After honing block bore, check bore
measurements to determine if standard
liner (Classification #1, #2, #3 or #4) can be
used. A push fit between liner and block is
desirable. If a push fit cannot be obtained,
block must be bored to receive an oversize
liner.
block, always lightly hone block bore (Para 4-36).
Change 1 4-149


Back to Top