TM-9-2815-202-34

ENGINE, DIESEL W/CONTAINER: MODEL 7083-7395, 7083-7396, 7083-7398 AND 7083-7399

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

FEBRUARY 1990

  TM-9-2815-202-34 - Page 344 of 670

TM 9-2815-202-34
4-41. BLOWER REPAIR (Cont)
(3)
(4)
(5)
(6)
(7)
Place clean folded wiping rag
between rotors (6 and 7). Remove six
bolts (8) and six Iockwashers (9)
securing blower drive coupling (10)
and retainer (11) to gear (12). Discard
Iockwashers.
Remove bolt (13), shaft (14), deflector
(15), and spacer (16).
Place flanges of two gear and bearing
pullers (with center screw backed out)
against faces of gears(12 and 17).
Aline flange holes with tapped holes
in gears.
Secure pullers to gears (12 and 17)
with 5/1 6-24 x 1 1/2-inch bolts. Install
two bolts on gear (17) and three bolts
on gear (12).
Turn two pullers uniformly and
remove gears (12 and 17) from shafts
of rotors (6 and 7). Remove pullers
from gears.
NOTE
Secure shims to matching gears to
insure identical number and size of
replacement shims during
reassembly.
(8) Remove shims (18) from shafts of
rotors (6 and 7).
(9) Remove twelve bolts (19), twelve
Iockwashers (20), and four retainers
(21 ) from blower end plates (22 and
23). Discard Iockwashers.
4-236


Back to Top