TM-9-2815-202-34

ENGINE, DIESEL W/CONTAINER: MODEL 7083-7395, 7083-7396, 7083-7398 AND 7083-7399

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

FEBRUARY 1990

  TM-9-2815-202-34 - Page 396 of 670

TM 9-2815-202-34
5-14. ACCESSORY DRIVE REPLACEMENT (Cont)
c. Cleanlng/inspection
(1) Clean all parts with fuel
bearing.
WARNING
Compressed air used
oil except
for
cleaning purposes will not
exceed 30 PSI. Use only with
effective chip guarding and
personal protective equipment
(goggles/shield, gloves, etc.).
(2)
(3)
(4)
Dry all parts with compressed air.
Inspect fiber coupling and shaft
coupling half for cracks, wear, or
damage.
Inspect bearing and sleeve for scores,
pitting, or wear.
d. Assembly
(1)
(2)
(3)
(4)
(5)
(6)
(7)
5-18
If removed, install cup plug (19) into
shaft coupling half (16).
Apply lubricant to each side of
bearing (17) prior to installing on shaft
coupling half (16).
Apply sealant to inner diameter of
bearing (17). Using arbor press, press
bearing onto shaft coupling half (16).
Apply sealant to inner diameter of
sleeve (18). Using arbor press, press
sleeve onto shaft coupling half (16).
Sleeve must be flush with end of
shaft.
Apply sealant to outer diameter of
bearing (17). Using arbor press, press
shaft coupling half assembly (14) into
accessory drive housing (13).
If removed, install seal (15), part
number out, into accessory drive
housing (13).
If removed, install six studs (12) into
accessory drive housing (13). Torque
studs to 12-17 Ib-ft (1 6-23 N-m).


Back to Top