TM-9-2815-202-34
ENGINE, DIESEL W/CONTAINER: MODEL 7083-7395, 7083-7396, 7083-7398 AND 7083-7399
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
FEBRUARY 1990
TM-9-2815-202-34 - Page 79 of 670
TM 9-2815-202-34
(9) Torque all bolts and nuts on brackets
to engine and container rail.
NOTE
Container 10909159 requires 80
units of desiccant, and container
10923108 requires 112 units.
(10) Fill desiccant basket, mounted on wall
of container, with desiccant.
CAUTION
Insure seal is properly seated in
track on lower container flange.
(11) If removed, install seal (7) in track on
container bottom.
(12) Apply sealant to container seal (7),
and position container seal on
container flange.
(13) Assemble top section of container (6)
to bottom section of container (62) by
matching alinement dowel on bottom
section flange with mating hole on top
section.
NOTE
●
For container 10923108, flat
washers are used in place of
Iockwashers to secure upper and
lower sections of container.
●
For container 10909159, torque
container bolts to 40-50 Ib-ft
(56-70 N-m).
●
For container 10923108, torque
container bolts to 88-105 Ib-ft
(123-147 N-m).
(14) Install forty-six bolts (2), forty-six
Iockwashers (3) and forty-six nuts (4),
Torque bolts.
(15) Pressurize the container to 5 psi (34
kPa) of dehydrated air and allow
container to stand for a minimum of
twelve hours, then check and verify
that air pressure is maintained.
3-25
Back to Top
