SMOKE GENERATION SYSTEM REPLACEMENT
2. Assemble solenoid bracket components.
a. Install pipe nipple (29) into one solenoid (20).
b. Install second solenoid (20) onto pipe nipple (29).
c. Place solenoid bracket (25) into a vice.
d. Install four screws (27) with flat washers (28) to secure solenoids (20)
to bracket (25).
e. Install elbow (19) into solenoid (20).
Install adapter (26) into elbow (19).
g. Install elbow (22) into solenoid (20).
Check position of electrical connectors on new solenoid valves.
the valve with the inlet port marked "IN" to the right and the outlet
port marked "OUT" to the left.
The electrical connectors must be
approximately 45 degrees from the inlet ports and pointing toward
If the connectors must be repositioned, place the valves in a soft jawed
Loosen the acorn nut on top of the valves.
Rotate the connectors
and tighten acorn nuts to 50 inch-pounds (5.65 N•m).
discard protective covers and felt filtering disks (if present) from inlet
and outlet ports.
WP 0094 00-11