TM-9-2815-237-34P
ENGINE, DIESEL: 8 CYLINDER, 6.2 AND 6.5, NORMALLY-ASPIRATED, DETUNED AND TURBOCHARGED
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2004
TM-9-2815-237-34P - Page 11 of 152
0001 00-6
TM 9-2815-237-34P
0001 00
USMC SMR Codes.
There are cases in TM 9-2815-237-34P where the USMC uses different SMR
codes than the Army. The list provided below identifies these differences and is for Marine Corps
use only. This list is the only place in TM 9-2815-237-34P where these differences appear. It is
recommended that Marine Corps technicians make the appropriate annotations within the body of
this technical manual. All items w/PB, PC, PE, PF, or PG in the first two positions of the SMRC will
be PA for the USMC.
FOR USMC USE ONLY
FIG
ITEM
MFG
ITEM
MARINE CORPS
NO
NO
P/N
NAME
PECULIAR SMRC
7
1
25534835
SCREW
PAHZZ
7
2
14022652
GEAR, HELICAL
PAHZZ
7
3
12337902
SCREW, CAP HEX
PAHZZ
7
4
14022648
WASHER, FLAT 12MM
PAHZZ
7
5
14022653
GEAR, HELICAL
PAHZZ
7
6
14022647
CHAIN, ROLLER
PAHZZ
7
7
14022645
SPROCKET WHEEL
PAHZZ
7
8
14022646
SPROCKET WHEEL
PAHZZ
7
8
10154689
SPROCKET WHEEL
PAHZZ
15
1
14059057
NOZZLE, FUEL INJ
PAOZZ
15
1
14063606
NOZZLE, FUEL INJ
PAOZZ
15
1
10233972
NOZZLE, FUEL INJ
PAOZZ
15
1
10233973
NOZZLE, FUEL INJ
PAOZZ
15
2
14025557
GASKET
PAOZZ
BOI.
The Basis of Issue (BOI) for the tools listed in section III of this RPSTL is as follows:
Level
Unit Description
BOI
Unit (O)
Maintenance unit, section or team (authorized a common
1
tool set)
Company/System Support Team
(except the following)
1
Motorized Division.Heavy Division
Heavy Maintenance Co.
2
Direct Support (DS)
Airborne/Assault Division
Forward Support Co.
2
Heavy Maintenance Co.
3
Light Infantry Division
Heavy Maintenance Co.
6
Light Maintenance Co.
0
General Support (GS)
Maintenance Co.
1
Heavy Equipment Maintenance Co.
2
The NSN’s
for the Unit, Direct and General Support Special Tool Kits are listed on page B-20, in
Section III of the TM 9-2320-280-20-3.
HOW TO LOCATE REPAIR PARTS
When National Stock Number or Part Number is Not Known.
(1) First.
Using the table of contents, determine the assembly group or subassembly group to which
the item belongs. This is necessary since figures are prepared for assembly groups and subassembly
groups, and listings are divided into the same groups.
{
{
{
Back to Top
