TM 9-2920-225-34
FRAME 2
1.
Press bearing (1) onto shaft of rotor (2) and into drive end bell (3).
2.
Put seal (4) into bearing retainer (5) with smooth side of seal facing outside
of retainer.
3.
Put large packing (6) around outer edge of bearing (1) and put bearing
retainer (5) in place.
4.
Put in four screws (7).
5.
Put small packing (8) around shaft and put seal sleeve (9) onto shaft with
counterbore of sleeve facing toward bearing (1).
END OF TASK
TA 103627
2-127