TM-9-3990-260-14-P

CONTAINER ROLL-IN/OUT PLATFORM (CROP) MODEL M3 AND MODEL M3A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JULY 2001

  TM-9-3990-260-14-P - Page 165 of 306

TM 9-3990-260-14&P
NOTE
Steps (17) through (20) are performed on both container transport locks.
(17)
Remove locking pin (11) from container transport lock (9).
NOTE
Latch should be extended as far into shoring slot of ISO container as possible.
Adjust position of four shim plates behind or in front of latch, as necessary.
(18)
Extend latch (12) into shoring slot (10) of ISO container (4).
(19)
Install locking pin (11) through shim plates (13) and latch (12) to secure latch in extended
position.
(20)
Close and secure ISO container (4) doors.
NOTE
Lock is shown in extended position seated in shoring slot.
b.
Unloading.
(1)
Open ISO container (4) doors and secure in open position.
NOTE
Steps (2) through (4) are performed on both container transport locks.
(2)
Remove locking pin (11) from container transport lock (9).
(3)
Retract latch (12) from shoring slot (10) of ISO container (4).
(4)
Install locking pin (II) thru shim plates (13) and latch (12) to secure latch in retracted posi-
tion.
7-29


Back to Top