TM-9-2815-213-34
ENGINE, DIESEL, WITH ACCESSORIES CUMMINS MODEL V8-300 (2815-910-8217)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING DIRECT SUPPORT AND GENERAL SUPPORT REPAIR PARTS LIST AND DEPOT MAINTENANCE ALLOWANCES)
FEBRUARY 1972
TM-9-2815-213-34 - Page 21 of 192
*TM 9-2815-213-34
Figure 2-5. Thermostat assembly--removal/installation.
Figure 2-6. Drive pulleys and vibration damper-
removal/installation.
(1) Loosen hose clamps on crossover to air
compressor flexible hose connection.
(2) Remove eight capscrews, lockwashers, and flat
washers securing crossover and preheater assembly to
intake manifolds.
(3) Disconnect flexible hose at air compressor and
remove crossover and preheater assembly from
manifolds. Remove and discard two gaskets.
j.
Intake Manifolds
(fig. 2-9).
(1) Remove eight capscrews, lockwashers,
and flat washers securing each manifold to each cylinder
head.
(2) Remove manifolds and gaskets.
k.
Water Crossover Pipe and Lifting Eyes
(fig. 2-
10).
(1) Remove eight capscrews and lockwashers
securing crossover and lifting eyes to cylinder heads.
(2) Remove crossover, lifting eyes, and two gaskets.
Figure 2 7. Water pump assembly--removal/installation.
2-6
Back to Top
