TM-9-2815-213-34
ENGINE, DIESEL, WITH ACCESSORIES CUMMINS MODEL V8-300 (2815-910-8217)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING DIRECT SUPPORT AND GENERAL SUPPORT REPAIR PARTS LIST AND DEPOT MAINTENANCE ALLOWANCES)
FEBRUARY 1972
TM-9-2815-213-34 - Page 23 of 192
*TM 9-2815-213-34
Figure 2-10. Water crossover pipe and engine lifting
eyes--removal/installation.
rear end of each cylinder head and remove cross-over
with flexible metallic drain return line at tached.
(6) Loosen two capscrews, securing fuel pump
support bracket (32, fig. B-18), to engine block.
(7) Remove four capscrews, lockwashers, and flat
washers, securing fuel pump to air compressor housing
and support bracket.
(8) Slide support bracket towards front, pull pump
towards front and remove from compressor. Remove
gasket.
(9) Remove two capscrews, lockwashers, and flat
washers securing bracket to block and remove bracket.
NOTE
The fuel pump is driven through a
freefloating coupling between the pump
and compressor. Insure that coupling
and plate are removed with pump.
m. Air Compressor and Drive Assembly
(fig. 1-2).
(1) Disconnect coolant input and output lines at
compressor.
(2) Disconnect air discharge line at compressor.
(3) Remove six capscrews (10, fig. B-25) and
lockwashers (9, fig. B-25) securing rear support (8, fig.
B-25) to flywheel housing.
(4) Remove support and gasket.
(5) Pull compressor and drive assembly toward front
of engine, to disengage compressor
drive gear from camshaft gear, and remove compressor.
n.
Oil Dipstick Tube Assembly
(fig. 2-11).
(1) Remove capscrew and lockwasher securing
tube clip to engine block.
(2) Disconnect tube at oil pan fitting and remove
tube.
Figure 2-11. Oil dipstick tube assembly-
removal/installation.
2-11.
Internal Components
a.
Cylinder Head Covers
(fig. 2-12).
(1)
Right Head Cover.
(a)
Remove ten capscrews, lockwashers, and plain
washers securing cover to head.
(b)
Remove cover and gasket.
(2)
Left Head Cover.
(a)
Loosen hose clamp securing breather tube to
crankcase breather and pressurizing unit (fig. 2-13).
(b)
Remove breather tube from unit.
2-8
Back to Top
