LO-9-2350-238-12
RECOVERY VEHICLE, FULL TRACKED LIGHT, ARMORED, M578
LUBRICATION ORDER
APRIL 1992
LO-9-2350-238-12 - Page 23 of 45
QUARTERLY NOTES (CONTINUED)
Note 38
BOOM CYLINDER HINGE PINS
Lubricate two fittings with GAA.
Note 39
TURRET BEARING
WARNING
Make sure no personnel are in turret well before
traversing cab.
Lubricate quarterly, after 75 hr of operation, or after each cleaning
operation, when turret well is exposed to steam or high-pressure
water.
A Apply GAA to both lubrication fittings (1) until clean grease is
observed at seals (2).
B Wipe away dirty grease that is forced through seals.
C Repeat until only clean grease is observed at seals.
D Traverse cab four complete revolutions, alternating left and
right.
Note 40
HYDRAULIC RESERVOIR BREATHER
WARNING
Dry cleanrng solvent (SD2) is toxic and flammable.
Wear protective goggles and gloves and use only in
well-ventilated area.
A Remove breather (1) and clean with solvent SD2.
B Dry, inspect, dip in oil (OE/HDO-10/OEA), and install.
LO 9-2360-238-12
Card 21 of 40
Back to Top
