MWO-9-1290-365-20-1
MODIFICATION OF M93 PALADIN MUZZLE VELOCITY SYSTEM
MODIFICATION WORK ORDER
DECEMBER 2005
MWO-9-1290-365-20-1 - Page 3 of 12
3
MWO 9-1290-365-20-1
d.
Parts Disposition.
See table 4 for a list of parts removed during application of this MWO:
Table 4.
Parts Removed During Application of MWO
NOMENCLATURE
NSN
Part Number
QTY
CAGEC
Transceiver
12979002
1 ea
19200
Mount, Resilient Gen
12922110
4 ea
19200
ATTACHING HARDWARE
Screws
MS51957-44
16 ea
96906
Lock washers
MS35338-137
16 ea
96906
Flat Washers
REW620C8L
16 ea
81349
Screw
438285-47
4 ea
07690
Lock Washer
MS35338-139
4 ea
80205
(1)
Transceiver instructions:
(a)
Transceivers shall be turned-in through respective property book offices for appropriate record-
keeping.
(b)
Transceiver(s) shall be wrapped in a manner which will offer some protection during shipment;
i.e., bubble wrap, foam inserts, standard Styrofoam packing, etc.
If possible, utilize the box/container and
packaging materiels that the upgraded transceivers were shipped in.
(c)
A DD1348 reflecting “M93 Transceiver, NSN 5895-01-417-7101, quantity, serial numbers, and
turn-in unit with a POC should be included in each box/container being turned-in.
(d)
M93 Transceivers to be upgraded should be shipped to DODAAC CMASD9, RIC CCA, citing
contract number DAAE20-03-C-0044.
In the clear address is as follows:
RSL Electronics, USA, Inc.
Borisch Manufacturing, Corp.
4511 East Paris, S. E.
Grand Rapids, MI
49512
(2)
Resilient Mounts identified in table 4, upon replacement, should be disposed of locally.
(3)
The attaching hardware for the Transceivers and Resilient Mounts, as identified in tables 3 and 4, are
the same.
If the upgraded transceiver is received without new attaching hardware, reuse the original attaching
hardware.
If new attaching hardware is included with the upgraded transceiver, the old attaching hardware
should be disposed of locally.
NOTE:
New hardware was not considered part of the upgrade or engineering change proposal, however,
after a few initial upgrades, the contractor is now including new attaching hardware with each upgraded
transceiver.
9.
SPECIAL TOOLS; TOOL KITS; JIGS; TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT
(TMDE); AND FIXTURES REQUIRED:
Tools identified in table 5 by Part Number and NSN can be substituted with other tools that perform the same function.
If
these items are not readily available at the organizational level, the direct support shop should have them.
Back to Top
