MWO-9-2320-280-20-6
MODIFICATION WORK ORDER
MODIFICATION OF 1-1/4 TON VEHICLES; HEAVY VARIANT, ARMAMENT CARRIER, AND EXPANDED CAPACITY VEHICLES M1097, M1097A1, M1025A2, M1097A2, M1113 AND M1114; AIRLIFT BUMPER REINFORCEMENT
JANUARY 2001
MWO-9-2320-280-20-6 - Page 4 of 18
Tool Kit, General Mechanic’s
50980
SC 5180-95-N26
b.
Tools necessary to apply MWO are contained in following shop set:
NOMENCLATURE
NSN
CAGEC
SUPPLY CATALOG
Shop Equipment, Automotive
19204
SC 4910-95-A74
Maintenance and Repair:
Organizational Maintenance,
Common No. 1
10. MODIFICATION PROCEDURE.
a. Vehicle Preparation.
(1)
Park vehicle and apply parking brake lever. (Refer to TM 9-2320-280-10 or TM 9-2320-387-10.)
(2)
Remove towing pintle assembly. (Refer to TM 9-2320-280-20 or TM 9-2320-387-24.)
(3)
Remove four nuts, screws, cover assembly, and trailer connector from receptacle mounting
bracket and rear bumper as shown in figure 1.
(4)
Remove two nuts, screws, and receptacle mounting bracket from rear bumper as shown in
figure 1.
(5)
Remove four nuts, eight washers, and four screws from rear bumper and bumper mounting
brackets as shown in figure 2.
b.
Airlift Bumper Reinforcement Installation.
(1)
Install 12469169 bumper reinforcement plate on rear bumper and bumper mounting brackets
with four B1821BH050C350N screws, eight existing washers, and four M45913/4-8CG8Z nuts as
shown in figure 3. Do not tighten nuts.
(2)
Install MS15001-4 lube fitting in 12469170 pintle bracket as shown in figure 4.
(3)
Install existing safety chain plate, support plate, spacer, and pintle bracket (12469170) on
bumper reinforcement plate and rear bumper with four B1821BH050C300N screws, eight
existing washers, and four M45913/4-8CG8Z nuts as shown in figure 4. Do not tighten nuts.
c.
Vehicle Final Preparation.
(1)
Route trailer connector through existing receptacle mounting bracket and install receptacle
mounting bracket on bumper reinforcement plate and rear bumper with two B1821BH025C150N
screws and 271172 nuts as shown in figure 5. Do not tighten nuts.
(2)
Install existing cover assembly and trailer connector on receptacle mounting bracket, bumper
reinforcement plate, and rear bumper with two B1821BH025C150N screws, two existing screws,
and four 271172 nuts as shown in figure 5.
(3)
Install towing pintle on bumper reinforcement plate and rear bumper with existing washer and
slotted nut as shown in figure 6. Loosen slotted nut slightly if towing pintle will not rotate easily.
(4)
Align hole in towing pintle and slotted nut and install MS24665-628 cotter pin through slotted
nut and towing pintle as shown in figure 6.
(5)
Tighten nuts installed in para. b, steps 1 and 3 to 90 lb-ft (122 N
•
m) as shown in figures 3 and 4.
(6)
Tighten nuts installed in para. c, steps 1 and 2 to 10 lb-ft (14 N
•
m) as shown in figure 5.
MWO 9-2320-280-20-6
4
Back to Top
