TB-9-2300-378-14

M48 & M60 SERIES VEHICLES

TECHNICAL BULLETIN; AIR INDUCTION SYSTEM MAINTENANCE

SEPTEMBER 1985

TB-9-2300-378-14 - Page 112 of 296

TB 9-2300-378-14

(5)

(6)

(7)

(8)

(9)

(lo)

(11)

(12)

(13)

(14)

(15)

Using

B).

Tape

Figure 4-27. Template fabrication

rule and scribe, scribe left and right vertical guide bars as indicated (view

cardboard to air outlet port to prevent cutting and grinding debris from

entering engine.

WARNING

Use approved eye protection

prevent serious eye injury.

Using hand grinder with cutting

guide bar.

Cut through weld on backside of

bar.

during

wheel,

grinding operations to

cut along scribed lines through vertical

guide bar between cut-off line and lower end of

Replace cut-off wheel with grinding wheel and remove remaining weld in cut-off

area.

Using rags and vacuum cleaner, remove cutting and grinding operation debris.

Prime and paint bare metal areas.

After paint has dried, wipe and vacuum inside of air cleaner housing to remove

paint overspray residue.

Remove cardboard and tape from air outlet port.

Inspect door seal. Replace if defective (TM-20).

Install air cleaner filter element (TM-20).

4-52