TB-9-2300-378-14

M48 & M60 SERIES VEHICLES

TECHNICAL BULLETIN; AIR INDUCTION SYSTEM MAINTENANCE

SEPTEMBER 1985

  TB-9-2300-378-14 - Page 160 of 296

TB 9-2300-378-14
(g)
(h)
(i)
(j)
Remove screw and lockwasher securing manifold secure bracket to air
cleaner. Discard lockwasher.
Slide hose onto manifold until ends of hoses are even with edge of manifold
Turn manifold until both inlet tubes are facing up. Remove manifold.
NOTE
It may be necessary to cut manifold hoses to remove the manifold.
Remove gasket and tubes from manifold. Scrape off any remaining gasket
material from manifold and air cleaner.
Remove screw and lockwasher securing manifold secure bracket to manifold
and remove bracket.
(2) Installation.
(a)
Attach manifold secure bracket to manifold with screw and new lockwasher.
Do not tighten.
(b)
Apply silicone compound (item 5, appendix C) inside three hoses (view A and
c).
(c)
Pu t
(d)
Pu t
(e)
Pu t
Slide two hoses (view C) on manifold.
four clamps on two hoses. Leave clamps loose.
new gasket (view C) on manifold flange.
manifold in position in air cleaner.
Slide two hoses on precleaned tubes.
Figure 6-11. Vehicle exhaust dust ejector system (VEDES) air cleaner manifold replacement.
6-38


Back to Top