TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 345 of 460

II106700-5

Rev. B

Page 81

c.

Install the cotter pin in the retaining pin and spread the cotter pin ends to hold it in

place.

d.

Repeat Steps “a” through “c” for the remaining tow shackle.

5.1.16

Re-install the Machine-Gun Mount (if required)

a.

Reverse the Upper Brush Guard Cover (bottom to top) (P/N 111437-1) to provide a

notch that allows the Machine Gun Mount support bars to attach to the Brush Guard

mounting structure (See Figure 49).

b.

Hoist the Machine-Gun Mount into place on the top of the cab.

e.

Replace the nuts, bolts, and washers previously removed into the mounting brackets

(two in the front and one in the back).

f.

Secure the Machine-Gun Mount in place using four bolts (3/8 – 16 x 4.500), eight

washers (3/8 ID), and four lock nuts (3/8 – 16).

If needed, optional longer bolts

(3/8 – 16 x 4.75) are included in the Extra Fastener Kit.

5.1.17

Re-install Vehicle Identification Plates

a.

Re-install the Vehicle Identification Plates from the OEM driver’s door onto the new

armored driver’s door using the urethane sealant (P/N 104302) used for the

windshield installation.