TB-9-2320-279-13-P-3
TECHNICAL BULLETIN; TANKER ARMOR MODULE KIT
OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST AND INSTALLATION INSTRUCTIONS)
JANUARY 2007
TB-9-2320-279-13-P-3 - Page 257 of 396
TB 9-2320-279-13&P
0040
0040-7
9. Install two 4397000-041 capscrews (4), 4397004-007 lockwashers (3), and 4397005-013
washers (2) as shown in figure 3.
Do not tighten capscrews (4) at this time.
10. Install 3286740 tanker light grommet (8) in right lower side panel assembly (1) and snap
wiring harness into grommet (8).
Refer to figure 3.
11. Install 4397000-382 capscrew (10), 4397004-009 lockwasher (11), and 4397005-016
washer (9) in upper rear edge of right lower side panel assembly (1) as shown in figure 3.
Do not tighten capscrew (10) at this time.
12. Install 4397000-041 capscrew (7), 4397004-007 lockwasher (6), and 4397005-013
washer (5) as shown in figure 3.
Do not tighten capscrew (7) at this time.
D. Install upper side panel assemblies as follows:
1. Install 6433307-01M1 or 6433307-200M1 left upper side panel assembly (12) and secure
to left lower side panel (7) with four 4397000-382 capscrews (11), 4397004-009
lockwashers (10), and 4397005-016 washers (16) as shown in figure 4.
Do not tighten
capscrews (11) at this time.
2. Install 4397000-382 capscrew (8), 4397004-009 lockwasher (9), and 4397005-016
washer (15) in rear edge of left upper side panel assembly (12) as shown in figure 4.
Do
not tighten capscrew (8) at this time.
3. Install 6433306-01M1 or 6433306-200M1 right upper side panel assembly (1) and secure
to right lower side panel (6) with four 4397000-382 capscrews (5), 4397004-009
lockwashers (4), and 4397005-016 washers (14) as shown in figure 4.
Do not tighten
capscrews (5) at this time.
4. Install five 4397000-382 capscrews (3), 4397004-009 lockwashers (2), and 4397005-016
washers (13) in rear edge of right upper side panel assembly (1) as shown in figure 4.
Do
not tighten capscrews (3) at this time.
E. Install front panel assemblies as follows:
NOTE
If pump module rear flange interferes with installation
of left or right front panel assemblies, remove material
to shorten pump module flange as required.
1. Install 6433257-01M1 or 6433257-200M1 left front panel assembly (9) and secure to left
lower side panel assembly (4) with two 4397000-382 capscrews (5), 4397004-009
lockwashers (6), 4397005-017 washers (7), and 4397064-007 locknuts (8) as shown in
figure 5.
Do not tighten locknuts (8) at this time.
Back to Top
