TB-9-2320-280-35-13

TECHNICAL BULLETIN

INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F

OCTOBER 2006

CHANGE 1

TB-9-2320-280-35-13 - Page 121 of 148

5-93

TB 9-2320-280-35-13

NOTE

Cut split in grommet to fit cables.

29-10.

Position grommet (33) over cables (6), (28), and (29).

29-11.

Install grommet (33) in hole (25).

29-12.

Route cables (6), (28), and (29) under fixed rear door (24) and along rear perimeter of left rear seat

back support (23). Secure cables (6), (28), and (29) to left seatback support (23) with three loop

clamps (30), screws (31), and plain-assembled nuts (32).

29-13.

Route cables (6), (28), and (29) through access hole (25) and grommet (33).

29-14.

Secure cables (6), (28), and (29) to left rear wheelhouse (26) with four loop clamps (30) and

self-tapping screws (27).

29-15.

Take all slack out of cables and store in seat well/utility area.

29-16.

Tighten screws and nuts on all clamps.

29-17.

Secure right-side tunnel insulation. (Refer to TM 9-2320-280-20.)

Figure 5-110.

27. SELF-TAPPING SCREW – 9421073 – QTY. 4

28. KDU CABLE – 10511-0704-040 – QTY. 1

29. POWER CABLE – 10181-9826-020 – QTY. 1

30. LOOP CLAMP – MS21333-74 – QTY. 7

31. SCREW – MS35206-265 – QTY. 3

32. NUT, PLAIN-ASSEMBLED – 271166 – QTY. 3

33. GROMMET – MS35489-24 – QTY. 1

6

29

28

26

~

25

23

~

24

30

30

30

32

32

31

32

33

~

27

27

30

30

27

31

30