TB-9-2320-280-35-14
TECHNICAL BULLETIN
INSTALLATION INSTRUCTIONS FOR SINGLE CHANNEL GROUND AND AIRBORNE RADIO SYSTEM (SINCGARS) AN/VRC-88F, AN/VRC-89F, AN/VRC-90F, AN/VRC-91F, AN/VRC-92F
SEPTEMBER 2006
TB-9-2320-280-35-14 - Page 72 of 148
5-50
TB 9-2320-280-35-14
NOTE
PLGR power cable positive lead insulation is ribbed.
20-24.
Attach shrink tubing (38) and terminal lugs (36) and (42) to PLGR power cable negative lead (41)
and PLGR power cable positive lead (39). (Refer to TM 9-2320-280-20 for terminal connector repair.)
20-25.
Attach PLGR power cable positive lead (39) to 24V terminal board (44) located on cab enclosure
panel (45) with existing nut (37).
20-26.
Attach PLGR power cable negative lead (41) to ground strap (43) located on cab enclosure panel
(45) with existing nut (37).
20-27.
Coil excess positive and negative power leads (39) and (41), place beneath ground strap (43), and
secure with tiedown strap (40).
NOTE
Ensure all excess antenna cable is inside cab of vehicle.
20-28.
Coil excess antenna cable and store under integrated rack using tiedown strap as necessary.
(Refer to figure 5-67.)
20-29.
Install right-side tunnel insulation. (Refer to TM 9-2320-280-20.)
Figure. 5-68.
36. TERMINAL LUG – 7728780 – QTY. 1
38. SHRINK TUBING – MS23053/4-302-0 – QTY. A/R
40. TIEDOWN STRAP – MS3367-1-0 – QTY. A/R
42. TERMINAL LUG – 7728777 – QTY. 1
45
36
37
40
37
41
38
42
43
44
38
39
~
Back to Top
