TB-9-2320-302-13-P-3
CREW PROTECTION KIT; AIR CONDITIONING KIT PART 3 OF 3
TECHNICAL BULLETIN; OPERATOR’S, UNIT, AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
MARCH 2008
TB-9-2320-302-13-P-3 - Page 189 of 240
RD-2-4663-0
(
REV —
)
PAGE 7
M915A2
Cut the Hose
Cut the hose to proper length with an
appropriate cutting tool. Aeroquip’s
hand-held cutter (79R8920) has been
specially designed for cutting all non-
wire reinforced hose. Be sure the cut is
made square to the hose length.
Slip Two Clips on the Hose
Slide two clips (be sure to use the
correct size) onto the cut end of the
hose. The orientation of the clips does
not affect the performance of the connecton. However, for ease of
assembly, both clips should be oriented in the same direction. NOTE:
If you don’t slide the clips over the hose at this time, you will have to
stretch the clips over the hose and fitting later. This may permantently
damage the clip.
Back to Top
