TB-9-2320-335-13-P

TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS

MAY 2008

TB-9-2320-335-13-P - Page 292 of 680

TB 9-2320-335-13&P

12-2

12-45. HYDRO-BOOST VENT LINE REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Applicable Models

All except M1114

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Materials/Parts

Locknut (Appendix A, Item 77)

Nut and lockwasher assembly

(Appendix A, Item 197)

Manual References

TM 9-2320-387-24P

Equipment Condition

Engine left splash shield removed

(para. 10-23 or para. 10-23.1).

Maintenance Level

Unit

1.

Disconnect hydro-boost vent line (2) from hydro-boost (1).

2.

Remove nut and lockwasher assembly (3), capscrew (10), clamp (4), harness clamp (9), and vent

line (2) from body (11). Discard nut and lockwasher assembly (3).

3.

Remove locknut (6), washer (7), capscrew (8), washer (7), clamp (5), and vent line (2) from body (11).

Discard locknut (6).

4.

Remove two clamps (4) and (5) from vent line (2).

1.

Install two clamps (4) and (5) on vent line (2).

2.

Install vent line (2) and clamp (5) on body (11) with washer (7), capscrew (8), washer (7), and

locknut (6). Tighten capscrew (8) to 6 lb-ft (8 N•m).

3.

Install vent line (2), harness clamp (9), and clamp (4) on body (11) with capscrew (10) and nut and

lockwasher assembly (3).

4.

Connect vent line (2) to hydro-boost (1).

b. Installation

a. Removal

FOLLOW-ON TASK: Install engine left splash shield (para. 10-23 or para. 10-23.1).