TB-9-2320-335-13-P
TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS
MAY 2008
TB-9-2320-335-13-P - Page 298 of 680
15-2
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Special Tools
Crowfoot, 5/8-in. (Appendix B, Item 138)
Torque adapter, 9/16-in.
(Appendix B, Item 133)
Torque adapter, 3/4-in.
(Appendix B, Item 134)
Adapter, 3/8-1/2-in. (Appendix B, Item 135)
Engine lifting sling (Appendix B, Item 24)
Materials/Parts
Three lockwashers (Appendix A, Item 144)
Eight locknuts (Appendix A, Item 106)
Two locknuts (Appendix A, Item 85)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-24-1
TM 9-2320-387-24P
Equipment Condition
•Fuel pump removed (right engine mount only)
(TM 9-2320-387-24-1).
•Engine right splash shield removed
(para. 10-24.1).
•Engine access cover removed
(TM 9-2320-387-24-1).
•Front propeller shaft removed (left engine
mount only) (para. 6-2).
•Glow plug controller removed
(TM 9-2320-387-24-1).
•Air horn support and engine lift bracket removed
(TM 9-2320-387-24-1).
General Safety Instructions
Direct all personnel to stand clear during
hoisting operation.
Maintenance Level
Direct support
15-3. ENGINE MOUNT AND INSULATOR MAINTENANCE
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP:
NOTE
• Left and right engine mounts are removed basically the same.
• Left and right engine mounts are not interchangeable with each
other.
1.
Remove two locknuts (6) and washers (7) from insulator (8) on engine mount bracket (5). Discard
locknuts (6).
2.
Loosen nut (9) securing starter (10) to starter support bracket (11).
3.
Remove three capscrews (4) and lockwashers (3) from right engine mount (1) and cylinder block (2).
Discard lockwashers (3).
4.
Remove four locknuts (16), washers (15), and capscrews (13) from two radiator supports (12) and
airlift brackets (14). Discard locknuts (16).
a. Removal
TB 9-2320-335-13&P
Back to Top
