TB-9-2510-251-13

TECHNICAL BULLETIN

OPERATOR AND FIELD MAINTENANCE; INSTALLATION MANUAL (INCLUDING REPAIR PARTS LIST); FOR ADD-ON-ARMOR (AoA) AIR CONDITIONING

AUGUST 2007

TB-9-2510-251-13 - Page 233 of 624

2-217

TB 9-2510-251-13

2-2.3

Installation of Air Conditioning Kit to M1097A2 Two-Door with O'Gara Hess

Add-on-Armor (Cont’d).

b. Install Evaporator and Condenser

(1)

Remove D-ring (1) located near passenger side seat on top of transmission tunnel.

(2)

Remove top screws attaching driver’s side mats to transmission tunnel.

(3)

Position evaporator drill template on transmission tunnel.

Center on D-ring hole and align

the driver’s side of the template parallel to the ribs on the transmission tunnel.

WARNING

When drilling through floor, use caution not to damage or drill into the fuel tank.

Failure to comply may cause damage to equipment and/or injury to personnel.

(4)

Using template as a guide, drill three 7/16 inch (.437) diameter holes.

De-burr holes.

(5)

Position hose routing template on driver’s side fender well.

Align the template to the upper

front corner of the fender well.

(6)

Using template as a guide, drill four 1 1/4 inch (1.25) diameter holes and de-burr.

1

3

2

7

9

6

HIDDEN

8

HIDDEN

8

HIDDEN

5

4

5

HIDDEN

10

HIDDEN

11

HIDDEN

11

HIDDEN

HIDDEN

10

Figure 2-317.

D-Ring

Figure 2-318.

Evaporator Brackets

(7)

Position evaporator brackets (2) on evaporator unit (3) and secure with four bolts (4) and

washers (5).

Align bottom of brackets to bottom of unit and tighten bolts.

(8)

Position vertical driver’s side evaporator bracket (6) on evaporator unit (3) and evaporator

bracket (2) and secure with two bolts (7) and washers (8) on top of bracket and two

bolts (9), four washers (10), and two locknuts (11) on bottom of bracket.