TB-9-3950-253-13-P

PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2009

  TB-9-3950-253-13-P - Page 113 of 704

0009-9
TB 9-3950-253-13&P
0009
RAISE A PARTIALLY SUBMERGED CONTAINER – CONTINUED
Attaching Lower Guides
0009
WARNING
During these adjustments, personnel are required to work outside the vehicle where there
are several projecting parts, and personnel are required to bend down. Take care when
bending and straightening. A hard hat is required. Failure to follow this warning may result
in injury to personnel.
NOTE
If misalignment is too great, lower section of lift frame may need to be repositioned by
either lowering (unloading) or raising (loading) hook.
Perform steps 1 through 5 for both right and left sides.
1. Check that hole in each lower guide (Figure 15, Item 3) is aligned with aperture in side of corner casting of
container (Figure 15, Item 2). Small amounts of misalignment may be acceptable.
2. Release anti-loose fastener (Figure 15, Item 4) that secures lower locking plate (Figure 15, Item 1).
3. Pull out locking plate (Figure 15, Item 1) and rotate it 90
°
to align locking pin with locking hole in lower guide
(Figure 15, Item 3).
4. Push locking plate (Figure 15, Item 1) to fully insert locking pin through locking hole in lower guide (Figure 15,
Item 3) and into corner casting.
5. Lock anti-loose fastener (Figure 15, Item 4) to hold locking plate (Figure 15, Item 1) in position.
Figure 15.
Lock Lower Guides.
09
467-182
2
3
2
1
4
3
4
1


Back to Top