TM-1-1500-344-23-4
CONSUMABLE MATERIALS AND EQUIPMENT FOR AIRCRAFT AND AVIONICS VOLUME IV
TECHNICAL MANUAL; CLEANING AND CORROSION CONTROL
SEPTEMBER 2013
TM-1-1500-344-23-4 - Page 81 of 92
NAVAIR 01-1A-509-4
TM 1-1500-344-23-4
01 September 2013
CHAPTER 4
SPECIAL AVIONIC EQUIPMENT
4-1. INTRODUCTION.
Table 4-1 describes the special
cleaning equipment used in the avionic corrosion
control work center. Pending standardization of support
equipment used for avionic cleaning, only equipment that
meets the speciFcations of Table 4-1 shall be used for
avionics cleaning track processes described in Volume III.
4-1/(4-2 Blank)
Table 4-1.
Special Support Equipment for
Avionics Cleaning
Nomenclature
Characteristics
Aqueous
Ultrasonic
Cleaner
Tank dimensions:
18" wide x 30" long x 18" deep
Overall dimensions:
20" wide x 32" long x 40" high
Power requirements:
Single phase/115V/60 Hz/60A
Operating frequency:
20 to 21 KHz (internally adjusted) at an
average power of 1500 watts (RMS)
Operating temperature:
130°± (54°C)
Temperature range:
90°± (32°C) to 150°± (66°C)
Solvent
Ultrasonic
Cleaner
Ultrasonic tank dimensions:
12" wide x 8" long x 12" deep
Vapor degreaser tank dimensions:
12" wide x 8" long x 12" deep
Overall dimensions:
48" wide x 60" long x 47" high
Power requirements:
Single phase/230V/50-60Hz/39A
Operating frequency:
40 KHz (internally set) at an average
power of 500 watts (RMS)
Operating temperature:
107°± (42°C)
Temperature range:
90°± (32°C) to 150°± (66°C)
Back to Top
