TM5-2330-378-14&P
4-16. TROUBLESHOOTINGCHART(continued).
a. LIGHTS (continued)
(4) STOPLIGHTS DO NOT WORK (M870) (continued).
CONTINUED
FROM STEP C
Replace red wire between stoplight andjunction
box under rear ramp of semitrailer
(refer to
wiring diagram, Appendix K). Verify problem is
solved.
Replace light assembly (para 4-32).
Verify
problem
is solved.
CONTINUED
FROM STEP A
D.
Remove cover from voltage reduction box (1).
Connect intervehicular cable to terminal. With
multimeter
set at 30 V c1c,place red probe on
terminal for red harness wire (refer to wiring
diagram, Appendix
K) on junction block and
ground
black probe while assistant
applies
brakes.
Does multimeter show any voltage?
9
Replace red wire from voltage reduction box to
junction box under rear semitraiter ramp (referto
wiring diagram, Appendix K). Verify problem is
solved.
E.
Disconnect intervehicular cable connector (2).
Using multimeter
set at 30 V c1c,place red probe
on pin for bad circuit, and place black probe on
good ground on towing vehicle.
Does multimeter
show any voltage?
2
co .
.....
...
on next page
ri
4-20