TM-5-2350-262-24P
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE; REPAIR PARTS AND SPECIAL TOOLS LIST (INCLUDING DEPOT MAINTENANCE REPAIR PARTS)
TM-5-2350-262-24P - Page 15 of 567
0001 00
TM 5--2350--262--24P
0001 00--5
EXPLANATION OF COLUMNS IN THE REPAIR PARTS AND SPECIAL TOOLS LIST WORK PACKAGES --
CONTINUED
FIG.
Column. This column lists the number of the figure where the item is identified/located. The figures are in
numerical order in the repair parts list and special tools list work packages.
ITEM
Column. The item number identifies the item associated with the figure listed in the adjacent FIG. column.
This item is also identified by the NSN listed on the same line.
2. Part Number (P/N) Index Work Package. P/Ns in this index are listed in ascending numeric--alpha sequence
(vertical arrangement of number and letter combinations which places the first digit or letter of each group in
order 0 through 9, followed by the letters A through Z and each following digit or letter in like order).
PART NUMBER
Column. Indicates the P/N assigned to the item.
FIG.
Column. This column lists the number of the figure where the item is identified/located in the repair parts list
and special tools list work packages.
ITEM
Column. The item number is in the number assigned to the item as it appears in the figure referenced in the
adjacent figure number column.
SPECIAL INFORMATION
UOC.
The UOC appears in the lower left corner of the Description Column heading. Usable on codes are shown
as “UOC:
}
” in the Description Column (justified left) on the first line under the applicable item/nomenclature.
Uncoded items are applicable to all models. Identification of the UOCs used in the RPSTL are:
Code
USED ON
MET
(ACE), M9, Armored Combat Earthmover
Fabrication Instructions.
Bulk materials required to manufacture items are listed in the bulk material functional
group of this RPSTL. Part numbers for bulk material are also referenced in the Description Column of the line
item entry for the item to be manufactured/fabricated. Detailed fabrication instructions for items source coded to
be manufactured or fabricated are found in TM 5--2350--262--20 or TM 5--2350--262--34.
Index Numbers.
Items which have the word BULK in the figure column will have an index number shown in the
item number column. This index number is a cross--reference between the NSN / P/N index work packages and
the bulk material list in the repair parts list work package.
HOW TO LOCATE REPAIR PARTS
1. When NSNs or P/Ns are not known.
First. Using the table of contents, determine the assembly group to which the item belongs. This is necessary
since figures are prepared for assembly groups and subassembly groups, and lists are divided into the same
groups.
Second. Find the figure covering the functional group or the subfunctional group to which the item belongs.
Third. Identify the item on the figure and note the number(s).
Fourth. Look in the repair parts list work packages for the figure and item numbers. The NSNs and part numbers
are on the same line as the associated item numbers.
2. When NSN is known.
First. If you have the NSN, look in the Stock Number column of the NSN index work package. The NSN is
arranged in NIIN sequence. Note the figure and item number next to the NSN.
Second. Turn to the figure and locate the item number. Verify that the item is the one you are looking for.
3. When P/N is known.
First. If you have the P/N and not the NSN, look in the Part Number column of the P/N index work package.
Identify the figure and item number.
Second. Look up the item on the figure in the applicable repair parts list work package.
Back to Top
