TM-5-2350-378-23-P
ARMORED COMBAT EARTHMOVER (ACE), M9; HYDRAULIC DIAGNOSTIC CENTER
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2012
TM-5-2350-378-23-P - Page 280 of 644
VEHICLE DOES NOT RESPOND TO OPERATOR CONTROLS - Continued
STEP
1.
Check if vehicle can move under its own power.
CONDITION/INDICATION
Does vehicle move under its own power?
DECISION
YES - Go to Step (2).
NO - Refer to Step (1) of All Hydraulic Functions Inoperative troubleshooting symptom (WP
0006).
STEP
2.
Perform oil flow test.
NOTE
•
Three personnel are required to perform this test.
•
Have suitable container ready to catch oil.
a.
Stop engine; relieve hydraulic pressure.
b.
Disconnect HYDR FLTR-IN-13R hose (Figure 1, Item 2) from high-pressure filter inlet port 13R
(Figure 1, Item 1).
2
T01603HDC
1
Figure 1.
High-Pressure Filter Inlet Port 13R.
c.
While assistant one is holding disconnected end of hose (Figure 1, Item 2) over container, assistant two
will hold fuel solenoid shutoff toggle switch (Figure 2, Item 2) on STE/ICE-R interface box
(Figure 2, Item 1) in shutoff position.
TM 5-2350-378-23&P
0018
0018-2
Back to Top
