TM-5-2815-241-34-P
ENGINE, DIESEL NTC-290
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
MARCH 1987
TM-5-2815-241-34-P - Page 126 of 738
TM 5-2815-241-34&P
CYLINDER HEAD FUEL LINE INSTALLATION
INITIAL SETUP
Tools
Materials/Parts
Extension, 6-inch, 1/2-inch drive
Handle, ratchet, 1/2-inch drive
Socket, 9/16-inch, 1/2-inch drive
Wrench, open-end, 1/2-inch
Wrench, open-end, 9/16-inch
Wrench, open-end, 5/8-inch
Lockwasher (three required)
Equipment Condition
Cylinder heads installed (page 2-68).
Air compressor and fuel pump installed
(page 2-86).
ACTION
LOCATION
ITEM
REMARKS
CAUTION
Do not overtighten fuel line fittings and fuel line nuts. Damage or leaks may result.
1. Rear cylinder
head (1)
Two fuel line
fittings (2)
Using 5/8-inch open-end wrench, screw
in.
Position fitting toward intake side of
engine and slightly downward.
NOTE
Position steel feed line on lower fitting.
2. Two fuel line
fittings (2)
3. Left side of
engine block (4)
4. Fuel shutoff
switch (8)
Two fuel line
nuts (3)
Using 1/2-inch open-end wrench, screw
in.
Do not tighten.
Three screws (5),
three new lock-
washers (6), and
three clamps (7)
with fuel lines
Using 1/2-inch drive 9/16-inch socket,
6-inch extension, and ratchet handle,
screw in.
Do not tighten.
Fuel line nut (9)
Using 5/8-inch open-end wrench and
1/2-inch open-end wrench, screw in and
tighten.
2-104
Back to Top
